Outgoing Authentication Protocol; Remote Node Network Layer Options; Figure 28-3 Menu 11.3 Remote Node Network Layer Options; Table 28-2 Menu 11.3 Remote Node Network Layer Options - ZyXEL Communications Prestige 662HW Series User Manual
802.11g wireless adsl 2+ 4 port security gateway
Hide thumbs
Also See for Prestige 662HW Series:
- Compact manual (39 pages) ,
- Specifications (2 pages) ,
- User manual (563 pages)
Table of Contents
Advertisement
28.2.3 Outgoing Authentication Protocol
For obvious reasons, you should employ the strongest authentication protocol possible. However,
some vendors' implementation includes specific authentication protocol in the user profile. It will
disconnect if the negotiated protocol is different from that in the user profile, even when the negotiated
protocol is stronger than specified. If the peer disconnects right after a successful authentication, make
sure that you specify the correct authentication protocol when connecting to such an implementation.
28.3 Remote Node Network Layer Options
For the TCP/IP parameters, perform the following steps to edit Menu 11.3 – Remote Node Network
Layer Options as shown next.
In menu 11.1, make sure IP is among the protocols in the Route field.
1.
Move the cursor to the Edit IP/Bridge field, press [SPACE BAR] to select Yes, then press
2.
[ENTER] to display Menu 11.3 – Remote Node Network Layer Options.
Menu 11.3 - Remote Node Network Layer Options
IP Options:
IP Address Assignment = Static
Rem IP Addr = 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
NAT= SUA Only
Address Mapping Set= N/A
Metric= 2
Private= No
RIP Direction= None
Version= RIP-1
Multicast= None
IP Policies=
Figure 28-3 Menu 11.3 Remote Node Network Layer Options
The next table explains fields in Menu 11.3
Table 28-2 Menu 11.3 Remote Node Network Layer Options
FIELD
IP Address
Press [SPACE BAR] and then [ENTER] to select Dynamic if the remote node is
Assignment
using a dynamically assigned IP address or Static if it is using a static (fixed) IP
address. You will only be able to configure this in the ISP node (also the one you
configure in menu 4), all other nodes are set to Static.
Rem IP Addr
This is the IP address you entered in the previous menu.
Remote Node Configuration
Enter here to CONFIRM or ESC to CANCEL:
Remote Node Network Layer Options.
–
DESCRIPTION
Prestige 662HW Series User's Guide
Bridge Options:
Ethernet Addr Timeout(min)= N/A
EXAMPLE
Dynamic
28-5
Advertisement
Table of Contents
