Editing Tcp/Ip Options (With Ethernet Encapsulation); Figure 5-4 Remote Node Network Layer Options - ZyXEL Communications Prestige 314 PLUS User Manual

FIELD
Period(hr)
Schedules
Nailed-Up
Connection
Session Options
Idle Timeout
5.2

Editing TCP/IP Options (with Ethernet Encapsulation)

Move the cursor to the Edit IP field in Menu 11.1, then press the [SPACE BAR] to set the value to Yes.
Press [ENTER] to open Menu 11.3 - Network Layer Options.
The next table gives you instructions about configuring remote node network layer options.
Remote Node Setup
Prestige 314 PLUS Broadband Sharing Gateway with 4-Port Switch
DESCRIPTION
This field is the time period that the budget should be
reset. For example, if we are allowed to call this remote
node for a maximum of 10 minutes every hour, then the
Allocated Budget(min) is (10 minutes) and the
Period(hr) is 1 (hour).
You can apply up to four schedule sets here. For more
details please refer to the Call Scheduling chapter.
This field specifies if you want to make the connection to
this remote node a nailed-up connection. More details
are given earlier in this section.
This value specifies the idle time (i.e., the length of time
there is no traffic from the Prestige to the remote node)
in seconds that can elapse before the Prestige
automatically disconnects the PPPoE connection. This
option only applies when the Prestige initiates the call.
Menu 11.3 - Remote Node Network Layer Options
IP Address Assignment= Dynamic
Rem IP Address= N/A
Rem IP Subnet Mask= N/A
My WAN Addr=0.0.0.0
Network Address Translation= SUA only
Metric= 1
Private= No
RIP Direction= None
Version= N/A
Multicast= None
Enter here to CONFIRM or ESC to CANCEL:
Press Space Bar to Toggle.

Figure 5-4 Remote Node Network Layer Options

EXAMPLE
1
300 seconds
(default)
5-7