Figure 226 Menu 11.2.2: Remote Node Network Layer Options; Table 158 Menu 11.3.2: Remote Node Network Layer Options - ZyXEL Communications ZyWALL 5 User Manual

ZyWALL 5 User's Guide

Figure 226 Menu 11.2.2: Remote Node Network Layer Options

The following table describes the fields in this menu.

Table 158 Menu 11.3.2: Remote Node Network Layer Options

FIELD
IP Address
Assignment
Rem IP
Address
Rem Subnet
Mask
My WAN
Addr
Network
Address
Translation
Metric
410
Menu 11.2.2 - Remote Node Network Layer Options
IP Address Assignment= Static
Rem IP Addr= 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
Network Address Translation= SUA Only
Metric= 15
Private= No
RIP Direction= None
Version= N/A
Multicast= None
Enter here to CONFIRM or ESC to CANCEL:
DESCRIPTION
If your ISP did not assign you a fixed IP address, press [SPACE BAR] and then
[ENTER] to select Dynamic, otherwise select Static and enter the IP address and
subnet mask in the following fields.
Enter the (fixed) IP address assigned to you by your ISP (static IP address assignment
is selected in the previous field).
Enter the subnet mask associated with your static IP.
Leave the field set to 0.0.0.0 to have the ISP or other remote router dynamically
(automatically) assign your WAN IP address if you do not know it. Enter your WAN IP
address here if you know it (static).
This is the address assigned to your local ZyWALL, not the remote router.
Network Address Translation (NAT) allows the translation of an Internet protocol
address used within one network (for example a private IP address used in a local
network) to a different IP address known within another network (for example a public IP
address used on the Internet).
Press [SPACE BAR] and then [ENTER] to select either Full Feature, None or SUA
Only.
Choose None to disable NAT.
Choose SUA Only if you have a single public IP address. SUA (Single User Account) is
a subset of NAT that supports two types of mapping: Many-to-One and Server.
Choose Full Feature if you have multiple public IP addresses. Full Feature mapping
types include: One-to-One, Many-to-One (SUA/PAT), Many-to-Many Overload,
Many- One-to-One and Server. When you select Full Feature you must configure at
least one address mapping set.
See Chapter 17 on page 281
Enter a number from 1 to 15 to set this route's priority among the ZyWALL's routes. The
smaller the number, the higher priority the route has.
for a full discussion on this feature.
Chapter 27 WAN and Dial Backup Setup