dumpPcapFrame
portRemoteMirrorTblDump
Using the show debug bridging command
Use the show debug bridging <value> command for debugging bridging problems only.
To use this command, you must enter one of the following subgroup parameters:
eap high-port <value> [low-port <value>]
mlt vlan <value>[low-mlt <value>] [high-mlt <value>] [low-port
<value>] [high-port <value>]
• low-mlt <value> = mlt id {1..128}
• high-mlt <value> = mlt id {1..128}
• low-port <value> = portnumber {slot/port[-slot/port][,...]}
• high-port <value> = portnumber {slot/port[-slot/port][,...]}
port port <value>
slpp vlan <value> [port <value>]
stp port <value> mlt <value> stg <value>
vlan vlan-id <value>
Using the show debug multicast command
Use the show debug multicast <value> command to debug multicast problems only.
To use this command, you must enter one of the following subgroup parameters:
• mgid-pep vrfid <value> verbose <value>
• igmp vrfid <value>
• ipmc vrfid <value> print <value>
• pgm
• pim vrfid <value> src-addr <value> grp-addr <value>
Important:
Troubleshooting
Command
Using the shell debug wrapper commands
Definition
Displays PCAP output but only on the slave
shell, not on the master.
Displays information about the remote
mirroring port table
July 2013
127