Determining The Data Stream Learned When Ip Multicast Over Spbm Is Configured On The Vlan - Avaya 8800 Troubleshooting Manual

Ethernet routing switch
Table of Contents

Advertisement

Determining the data stream learned when IP multicast over SPBM is configured on the VLAN

Determining the data stream learned when IP multicast over
SPBM is configured on the VLAN
To determine the data stream learned when IP multicast is configured on the VLAN, use the
following procedure:
Procedure steps
Determine the data stream learned using the following command:
show ip mroute route
Job aid: show ip mroute route command
The following table shows the field descriptions for this command.
Table 27: Job aid: show ip mroute route command output
GROUP
SOURCE
SRCMASK
UPSTREAM_NBR
IF
Troubleshooting
Field
Indicates the IP multicast group for which this entry
specifies a next hop on an outgoing interface
Indicates the network address that, when combined
with the corresponding value of
ipMRouteNextHopSourceMask, identifies the sources
for which this entry specifies a next hop on an outgoing
interface
Indicates the network mask, when combined with the
corresponding value of ipMRouteNextHopSource,
identifies the sources for which this entry specifies a
next hop on an outgoing interface
Indicates the address of the upstream neighbor from
which IP datagrams from these sources to this
multicast address are received, or 0.0.0.0 if the
upstream neighbor is known
Indicates the value of ifIndex for the interface on which
IP datagrams sent by these sources to this multicast
address are received. A value of 0 indicates that
datagrams are not subject to an incoming interface
Description
July 2013
407

Advertisement

Table of Contents

Troubleshooting

loading

This manual is also suitable for:

8600

Table of Contents