Avaya 8800 Troubleshooting Manual page 159

mode <source|termination>
remove-vlan-id <vlan-id>
srcmac <Srcmac>
Example of remote mirroring configuration using ACLs
Remote mirroring is configured for the network shown in the following figure. Because R
modules are used, ACLs are also used.
Figure 4: Remote mirroring network example
Configure an ACL-based mirroring entry on Switch 1 (S1).
Troubleshooting
Variable Value
Specifies whether the port is an RMT (mode is
termination) or an RMS (mode is source).
Removes a VLAN from the VLAN list. Used only
for RMT ports. When the RMT port is removed
from the last VLAN in the list, RMT is disabled
from the port.
Configures the source MAC address for use in
the remote mirroring encapsulation header. The
mirrored packet is sent from the RMS port, and
the source MAC parameter in the header is
derived from this address. The source MAC
address of the encapsulated frame contains the
first 45 bits of this MAC address. The three least
significant bits are derived from the port number
of the RMS port. The MAC address of the port is
used as the default value.
Remote mirroring configuration
July 2013 159