Testing The Switch Fabric - Avaya 8800 Troubleshooting Manual

Software troubleshooting tool configuration using ACLI
2. In Global Configuration mode, disable PCAP globally:
3. Make desired PCAP modifications.
4. Reset PCAP statistics and counters:
5. In Global Configuration mode, globally enable PCAP:
6. In Interface Configuration mode, enable PCAP:

Testing the switch fabric

You can test the switch fabric for consistency. The fabric test causes the CPU to generate
traffic and send it through the switch fabric. The CPU generates little traffic.
Prerequisites
• Access Privileged EXEC mode.
Procedure steps
1. Test the switch fabric by entering the following command.
2. Stop the test after a few seconds:
3. View the results of the test:
256 Troubleshooting
no pcap enable
no pcap enable
pcap reset-stat
pcap enable
pcap enable [mode <tx|rx|both|rxFilter|txFilter|bothFilter>]
test fabric
test stop fabric
show test fabric
Currently no test is running.
Last test results:
IfIndex: 0
Result: success
Comments? infodev@avaya.com
July 2013