Avaya 8800 Troubleshooting Manual page 422

Multicast troubleshooting using the ACLI
show ip mroute route
Job aid: show ip mroute route command
The following table shows the field descriptions for this command.
Table 36: Job aid: show ip mroute route command output
GROUP
SOURCE
SRCMASK
UPSTREAM_NBR
IF
EXPIR
PROT
422 Troubleshooting
Field
Indicates the IP multicast group for which this entry
specifies a next hop on an outgoing interface
Indicates the network address that, when combined
with the corresponding value of
ipMRouteNextHopSourceMask, identifies the sources
for which this entry specifies a next hop on an outgoing
interface
Indicates the network mask, when combined with the
corresponding value of ipMRouteNextHopSource,
identifies the sources for which this entry specifies a
next hop on an outgoing interface
Indicates the address of the upstream neighbor from
which IP datagrams from these sources to this
multicast address are received, or 0.0.0.0 if the
upstream neighbor is known.
Indicates the value of ifIndex for the interface on which
IP datagrams sent by these sources to this multicast
address are received. A value of 0 indicates that
datagrams are not subject to an incoming interface
check, but can be accepted on multiple interfaces (for
example, in CBT).
Indicates the minimum amount of time remaining
before this entry ages out. The value 0 indicates that
the entry is not subject to aging.
Indicates the outgoing mechanism through which the
switch learns this route. For IP multicast over SPBM,
this value is sb-access or spb-network. Spb-access
indicates the datastream learned was from the UNI
ports. Spb-network indicates that the datastream
learned was from the SPBM cloud.
Comments? infodev@avaya.com
Description
July 2013