Configuring Global Mirroring Actions With An Acl - Avaya 8800 Troubleshooting Manual

Software troubleshooting tool configuration using ACLI
2. Mirror both ingress and egress traffic passing through port 7/1:
3. Enable mirroring for the instance:

Configuring global mirroring actions with an ACL

Configure the global action to mirror to mirror packets that match an ACE.
Prerequisites
• The ACL exists.
• Enter Global Configuration mode.
Procedure steps
To set the global action for an ACL, use the following command:
filter acl set <1-4096> global-action <count|count-ipfix|ipfix|
mirror|mirror-count|mirror-count-ipfix|mirror-ipfix>
<1-4096> specifies an ACL ID from 1 to 4096.
Variable definitions
Use the information in the following table to help you use the filter acl set <1-4096>
commands.
global-action
<count|count-ipfix|
ipfix|mirror|
mirror-count|
mirror-count-ipfix|
mirror-ipfix>
240 Troubleshooting
The analyzer is connected to port 7/2.
mirror-by-port 3 mode both
mirror-by-port 3 enable
Variable
Specifies the global action to take for matching ACEs:
mirror, count, mirror-count, ipfix, mirror-ipfix, count-ipfix, or
mirror-count-ipfix.
If you enable mirroring, ensure you specify the source and/
or destination mirroring ports:
• For R modules in Tx modes: use
commands to specify mirroring ports.
• For R and RS/8800 modules in Rx modes: use the
filter acl ace debug
Comments? infodev@avaya.com
Value
mirror-by-port
commands to specify
July 2013