Dumping Rsp Packet Tracing - Avaya 8800 Troubleshooting Manual

no
Job aid
The following table describes the fields for the show rsp-trace command.
ingress-pkt-trace:/egress-pkt-trace:
port
state
interval

Dumping RSP Packet Tracing

Dump the RSP Packet Tracing to display the ingress and egress RSP Tracing information that
is collected by enabling the tracing.
Troubleshooting
Variable
Field
Value
The interval is an optional parameter. If you
do not configure the interval, the default
value is 1 second. If you do configure it, the
time interval changes immediately. On all
subsequent occasions when you enable rsp-
trace, if you do not specify a new interval
value, it is set to the previously set interval
value. This eliminates the need to change the
configuration every time you use this
command.
Disables ingress or egress Packet Tracing.
Description
Specifies the Packet Tracing as ingress or
egress.
Specifies all the ports in the lane on which
the trace is enabled.
Important:
After the trace is disabled internally (when
the interval timer expires), the ports are
not displayed in the output of the
rsp-trace info
Specifies whether Packet Tracing is
enabled.
Specifies the interval in seconds for which
the Packet Tracing is enabled.
Dumping RSP Packet Tracing
config
command.
July 2013 229