Using Spbm Debugging Commands - Avaya 8800 Troubleshooting Manual

Variable definitions
Use the information in the following table to use the debug commands.
<nbr_ipaddr|peer-group-name>
mask <WORD 1-100>

Using SPBM debugging commands

Use the SPBM debug commands to display specific debug messages for your Shortest Path
Bridging (SPB) configuration. You can use these commands to troubleshoot your SPB
configuration.
SPBM debugging is done through Connectivity Fault Manager (CFM). For information about
using CFM, see Avaya Ethernet Routing Switch 8600/8800 Configuration—Shortest Path
Bridging MAC (SPBM), NN46205–525.
Prerequisites
• Access Privileged EXEC Mode.
Procedure steps
1. Display specific debug messages for your SPB IS-IS configuration using the
2. Display specific debug messages for your SPB Layer 2 VPN configuration using
Variable definitions
Use the information in the following table to use the debug spbm commands.
Troubleshooting
trace level 52 3
Variable
following commands:
config ip spbm isis recompute-fib
config ip spbm isis recompute-fib-download
the following commands:
config ip spbm l2vpn action-call index <value>
config ip spbm l2vpn event-notify event <value>
config ip spbm l2vpn fib-update
config ip spbm l2vpn fib-update-cvlan c-vid <value>
Value
Specifies the peer IP address or the peer group
name.
Specifies one or more mask choices that you enter,
separated by commas with no space between
choices. For example: [<mask>,<mask>,<mask>...].
Options include: none, all, error, packet, event, trace,
warning, state, init, filter, update.
Using SPBM debugging commands
July 2013 235