Avaya 8800 Troubleshooting Manual page 153

Procedure steps
1. Configure the debug actions to mirror using the following command:
2. Ensure the configuration is correct:
Variable definitions
Use the information in the following table to help you use the config filter acl <acl-
id> ace <ace-id> debug mirror commands.
mirror <enable|
disable>
mirroring-dst-ports
<value>
mirroring-dst-vlan
<value>
mirroring-dst-mlt
<value>
Example of configuring R module txFilter mode mirroring
Troubleshooting
config filter acl <acl-id> ace <ace-id> debug [mirror
<enable|disable>] [mirroring-dst-ports <value>] [mirroring-
dst-vlan <value>] [mirroring-dst-mlt <value>]
<acl-id> specifies an ACL ID from 1 to 4096.
<ace-id> specifies an ACE ID from 1 to 1000.
show filter acl debug [<acl-id>] [<ace-id>]
Variable
Enables or disables mirroring for the ACE.
If you enable mirroring, ensure that you configure the
appropriate parameters:
• For R and RS/8800 modules in Rx mode, use
mirroring-dst-ports
vlan mirroring-dst-mlt
, or
• For R modules in Tx mode, use the
mirror-by-port commands to specify the
mirroring source/destination.
Specifies the destination port or ports for mirroring.
Specifies the destination VLAN for mirroring.
Specifies the destination MLT group for mirroring.
Port mirroring configuration
Value
, mirroring-dst-
.
config diag
July 2013 153