Avaya 8800 Troubleshooting Manual page 230

Software troubleshooting tool configuration using ACLI
Prerequisites
• Log on to Global Configuration mode.
Procedure steps
Important:
The CLI command accepts only a single port.
Important:
RSP Packet Tracing displays only the last 1024 packets captured.
1. Display the specific egress RSP packet by using the following command:
2. Display the ingress Packet Tracing by using the following command:
Variable definitions
Use the information in the following table to help you complete the preceding procedure
steps.
<slot/port>
230 Troubleshooting
dump rsp-trace egress-display-pkt <slot/port> <pkt-id>
OR
Display the specific ingress RSP packet by using the following command:
dump rsp-trace ingress-display-pkt port <slot/port> <pkt-id>
dump rsp-trace ingress-pkt-trace <slot/port> [<start-pkt>
<end-pkt>]
OR
Display the egress Packet Tracing by using the following command:
dump rsp-trace egress-pkt-trace <slot/port> [<start-pkt>
<end-pkt>]
Variable
Comments? infodev@avaya.com
Value
Specifies a port in the lane for which to
display the trace.
July 2013