Using The Show Debug Multicast Command; Show Debug Ip Pim Command - Avaya 8800 Troubleshooting Manual

Software troubleshooting tool configuration using ACLI
port port <value>
slpp vlan <value> [port <value>]
stp port <value> mlt <value> stg <value>
vlan vlan-id <value>

Using the show debug multicast command

Use the show debug multicast <value> command to debug multicast problems only.
To use this command, you must enter one of the following subgroup parameters:
• mgid-pep vrfid <value> verbose <value>
• igmp vrfid <value>
• ipmc vrfid <value> print <value>
• pgm
• pim vrfid <value> src-addr <value> grp-addr <value>
Important:
PIM has another debugging command called config ip pim debug-pimmsg. For
more information, see

show debug ip pim command

Use the show debug ip pim [vrf <value>] [vrfids <value>] command for
debugging PIM problems only. The following shows sample output of this command, which is
the same as debug ip pim. For more information, see
page 232.
ERS-8610:5#show debug ip pim
***********************************************************************
Command Execution Time: SUN AUG 29 10:56:34 2010 UTC
***********************************************************************
PIM configuration - GlobalRouter
-------------------------------------
CLI session configuration
214 Troubleshooting
Using PIM debugging commands
assert : false
bstrap : false
group : 0.0.0.0
hello : false
joinprune : false
pimdbglog : false
register : false
regstop : false
rp-adv : false
send : false
rcv : false
source : 0.0.0.0
Comments? infodev@avaya.com
on page 143.
Using PIM debugging commands on
July 2013