Software troubleshooting tool configuration using ACLI
trace mpls ipv4
<A.B.C.D/X>
trace mpls rsvp <WORD
0-32>
trace route-map <on|off>
trace syslog
r-module <1-10> trace
Using ACLI for troubleshooting
You can use ACLI to help provide diagnostic information.
Prerequisites
• Access Privileged EXEC mode.
Procedure steps
1. Prior to capturing data it is useful to disable scrolling of the output display. To do
200
Troubleshooting
Command
this, issue the following command:
Comments? infodev@avaya.com
Parameters
<cr>
source <A.B.C.D>
ttl <1-255>
<cr>
source <A.B.C.D>
ttl <1-255>
<cr>
address <A.B.C.D>
iflist <WORD 1-256>
name <WORD 1-64>
protocol <rip|ospf|bgp|dvmrp|any>
type <accept|announce>
destination <ipaddr> [next-hop-
mac <mac>] [port <slot/port>]
[vlan <vlanId>]
enable
disable
grep [<WORD 0-1024>]
level [<67-90> <0-4>]
July 2013