Avaya 8800 Troubleshooting Manual page 142

Software troubleshooting tool configuration using CLI
Procedure steps
Important:
The CLI command accepts only a single port.
Dump ERCD records:
dump ercdRecord {arp slot <value> | ip slot <value> | ip_subnet
port <value> | mac slot <value> port <value>| mac_vlan port
<value> | mgid slot <value> | protocol port <value> | vlan port
<value> } [verbose <value>]
Variable definitions
The following table describes the variables that you use with the dump ercdRecord
command.
arp
ip
ip-subnet
mac
mac_vlan
mgid
protocol
vlan
slot <value>
port <value>
142 Troubleshooting
Variable
Comments? infodev@avaya.com
Value
Specifies ARP ERCD records.
Specifies IP ERCD records.
Specifies IP subnet ERCD records.
Specifies MAC ERCD records. Displays the
learned MAC entries for the specified port
that are present on the COP and the
corresponding VLAN record of the port to
check if the MAC entry learned against one
port is downloaded properly to all available
slots.
Specifies MAC VLAN ERCD records.
Specifies MGID ERCD records.
Specifies protocol ERCD records.
Specifies VLAN ERCD records. Displays the
VLANs to which this port belongs and the
corresponding ingress VLAN records of this
port.
Specifies the slot number to which you send
the query.
Specifies the port number {slot/port} for
which you get the records.
July 2013