Chapter 15: Snmp Trap Configuration Using Cli; Roadmap Of Snmp Trap Cli Commands - Avaya 8800 Troubleshooting Manual

Chapter 15: SNMP trap configuration using
Use Simple Network Management Protocol (SNMP) traps and notifications to allow management stations
to gather information about switch activities, alarms, and other information.
In CLI, to configure traps you configure SNMP trap notifications, create a target address to which you
want to send the notifications, and then specify target parameters.
Specify which protocols and processes generate traps by enabling traps for that protocol. For example,
to allow OSPF to generate SNMP traps, use the following command: config ip ospf trap
enable.
For information about how to configure SNMP community strings and for related topics, see Avaya
Ethernet Routing Switch 8800/8600 Security, NN46205-601.

Roadmap of SNMP trap CLI commands

The following roadmap lists some of the CLI commands and their parameters that you can use
to complete the procedures in this section.
config snmp snmplog
config snmp-v3 notify
config snmp-v3 ntfy-
filter
Troubleshooting
CLI
Command Parameter
enable <true|false>
info
maxfilesize <64 to 256000>
create <Notify Name> [tag <value>]
[type <value>]
delete <Notify Name>
info
tag <Notify Name> new-tag <value>
type <Notify Name> new-type
<value>
create <Profile Name> <subtree
oid> [mask <value>] [type <value>]
July 2013 281