Dumping Specified Ercd Records - Avaya 8800 Troubleshooting Manual

<pkt-id>
<start-pkt>
<end-pkt>

Dumping specified ERCD records

Dump a specified Enterprise RSP Control Driver (ERCD) record to view that record.
Prerequisites
• Log on to Global Configuration mode.
Procedure steps
Important:
The CLI command accepts only a single port.
Dump ERCD records:
dump ercdRecord {arp <slot> | ip <slot>| ip_subnet <slot/port>|
mac <slot> | mac_vlan <slot/port> | mgid <slot> | protocol
<slot/port> | vlan <slot/port>} [verbose <value>]
Variable definitions
The following table describes the variables that you use with the dump ercdRecord
command.
Troubleshooting
Variable
Dumping specified ERCD records
Value
Specifies the ID as an integer of the packet
to display.
value specifies the packet ID as an integer in
the range of 1–1024.
Specifies the packet ID of the first packet to
display as an integer in the range of 1–
1024.
Specifies the packet ID of the last packet to
display as an integer in the range of 1–
1024.
July 2013 231