Running An Ipv6 Traceroute Test; Configuring Ping Snoop For R Series Modules - Avaya 8800 Troubleshooting Manual

Software troubleshooting tool configuration using CLI
traceroute 100.100.1.1 1444 vrf 100 source 200.100.1.1
traceroute to 100.100.1.1, 30 hops max, 1500 byte packets (vrf 100)
1

Running an IPv6 traceroute test

Use traceroute to determine the route packets take through a network to a destination.
Procedure steps
To use traceroute, enter the following command:
traceroute <ipv6addr> [<datasize>] [-m <value>] [-p <value>] [-
q <value>] [-w <value>] [-v] [source <value>]
Variable definitions
Use the information in the following table to help you use the traceroute <ipv6addr>
command.
-m <value>
-p <value>
-q <value>
-v
-w <value>
datasize <value>
source <value>

Configuring ping snoop for R series modules

Use Ping Snoop to troubleshoot multilink trunking configurations.
The predefined ACL and ACTs for ping snoop are numbered 4096. You can use your own
ACT, ACL, and ACE instead, but you are duplicating the ACT, ACL, and ACE that the system
predefines.
Configure the ACE action, debug action, and the IP addresses that you require.
190 Troubleshooting
100.100.1.1 1.263 ms 0.799 ms 0.725 ms
Variable
Comments? infodev@avaya.com
Value
Specifies the is maximum time-to-live (TTL) (1 to
10).
Specifies the base UDP port number (1 to 65535).
Specifies the number of probes per TTL (1 to 255).
Specifies verbose mode (detailed output).
Specifies the wait time per probe (1 to 255).
Specifies the size of the probe packet (56 to 1232).
Specifies the source IPv6 address for use in IPv6 VPN
traceroutes.
July 2013