Avaya 8800 Troubleshooting Manual page 160

Software troubleshooting tool configuration using CLI
Procedure steps
1. Create a new ACT with ID 2:
2. Select the IP attributes:
3. Select the protocol attributes:
4. Enable ACT 2:
Configure the Access Control List (ACL).
Procedure steps
1. Create ACL 1 of type ingress VLAN:
2. Add ingress VLAN of 220:
Add Access Control Entries (ACE) to ACL 1.
Procedure steps
1. Add ACE 1 with action of permit to use to mirror ICMP traffic:
2. Add ACE 2 with action of permit to use to mirror TCP traffic with a destination port
160 Troubleshooting
ERS-8610:5# config filter act 2 create
ERS-8610:5# config filter act 2 ip ipProtoType
ERS-8610:5# config filter act 2 protocol tcpDstPort
ERS-8610:5# config filter act 2 apply
ERS-8610:5# config filter acl 1 create inVlan act 2
ERS-8610:5# config filter acl 1 vlan add 220
ERS-8610:5# config filter acl 1 ace 1 create name icmp
ERS-8610:5# config filter acl 1 ace 1 action permit
ERS-8610:5# config filter acl 1 ace 1 debug mirror enable
ERS-8610:5# config filter acl 1 ace 1 debug mirror out-port
2/29
ERS-8610:5# config filter acl 1 ace 1 ip ip-protocol-type eq
icmp
ERS-8610:5# config filter acl 1 ace 1 enable
range from 20 to 500:
ERS-8610:5# config filter acl 1 ace 2 create name tcp_range
ERS-8610:5# config filter acl 1 ace 2 action permit
ERS-8610:5# config filter acl 1 ace 2 debug mirror enable
ERS-8610:5# config filter acl 1 ace 2 debug mirror out-port
2/29
Comments? infodev@avaya.com
July 2013