Avaya 8800 Troubleshooting Manual page 170

Software troubleshooting tool configuration using CLI
info
packet-count
<PacketCount>
pbits <Pbits> [to
<value>] [match-zero
<value>] [not]
protocol-type
<protocoltype> [to
<value>] [not]
refresh-timer
<RefreshTimer>
srcip <ipaddr> [to
<value>] [not]
srcmac <SrcMac> [mask
<value>] [not]
170 Troubleshooting
Variable
not
than the range of values defined.
Displays the current PCAP filter configuration.
When set, PCAP stops after capturing the specified
number of packets. This is similar to the refresh-timer
option; after it is invoked, the filter is disabled. This option
is active only when the action parameter is set to trigger-
on. The default value is 0, which means this option is
disabled.
Specifies the priority bit of the packet.
<Pbits>
0, which means this option is disabled.
to <value>
<value>
to true, 0 is considered a valid value. When it is set to
false, 0 is considered a disable value.
not
than the range of values defined.
Specifies the protocol of the packet.
<protocoltype>
protocol-type values. The default is 0, which means this
option is disabled.
to <value>
not
than the range of values defined.
When set, this starts or resets a timer. If another packet
is not received within the specified time, PCAP is
disabled globally. This option is active only when the
action parameter is set to trigger-on. To delete this
option, set it to 0. The default value is 0.
Specifies the source IP address.
<ipaddr>
addresses. The default is 0.0.0.0, which means this
option is disabled.
to <value>
not
than the range of values defined.
Specifies the MAC address of the source.
<SrcMac>
set, then only the first few bytes are compared. The
default is 00:00:00:00:00:00, which means this option is
disabled.
mask <value>
address. This parameter specifies an address range.
Comments? infodev@avaya.com
Value
means that the filter matches for all other values
can be one value or a range. The default is
specifies a range.
is either true or false. When this option is set
means that the filter matches for all other values
can be one value or a range of
specifies a range.
means that the filter matches for all other values
can be one address or a range of IP
specifies a range.
means that the filter matches for all other values
is the source MAC address. If the mask is
is the mask of the source MAC
July 2013