Avaya 8800 Troubleshooting Manual page 395

Determining the data stream learned when IP multicast over SPBM is configured on the VLAN
Procedure steps
In the navigation tree, open the following folders: Configuration > IP > Multicast.
Variable definitions
Use the information in the following table to help you use the Multicast tab.
Group
Source
SourceMask
UpstreamNeighbor
Interface
ExpiryTime
Protocol
Troubleshooting
Field
Indicates the IP multicast group for which this entry
specifies a next hop on an outgoing interface
Indicates the network address that, when combined
with the corresponding value of
ipMRouteNextHopSourceMask, identifies the sources
for which this entry specifies a next hop on an outgoing
interface
Indicates the network mask, when combined with the
corresponding value of ipMRouteNextHopSource,
identifies the sources for which this entry specifies a
next hop on an outgoing interface
Indicates the address of the upstream neighbor from
which IP datagrams from these sources to this
multicast address are received, or 0.0.0.0 if the
upstream neighbor is known
Indicates the value of ifIndex for the interface on which
IP datagrams sent by these sources to this multicast
address are received. A value of 0 indicates that
datagrams are not subject to an incoming interface
check, but can be accepted on multiple interfaces (for
example, in CBT).
Indicates the minimum amount of time remaining
before this entry ages out. The value 0 indicates that
the entry is not subject to aging.
Indicates the outgoing mechanism through which the
switch learns this route. For IP multicast over SPBM,
this value is sb-access or spb-network. Spb-access
indicates the datastream learned was from the UNI
ports. Spb-network indicates that the datastream
learned was from the SPBM cloud.
Description
July 2013 395