Xerox DocuPrint 96 Message Manual page 96

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-18
OS1190 Invalid parameter, command ignored.
An undefined bin is specified or the sheet count for the bin is not
within the allowable range.
Action 1. Verify the bin and reenter the command
or
2. Change the BLIMIT command to allow your number of sheets.
(The allowable range is 100-2500 sheets.)
or
3. An undefined tray is specified in the command. Verify the tray
number and reenter the command. (The allowable trays are 1-
6.)
OS1195 Undefined ink: color
The ink you specified (represented by the word color in the message
shown) is incorrect.
Action 1. Check to make sure that the ink name is entered correctly.
2. If the message reappears, consult your systems specialist.
OS1200 Command not allowed while HIP or SDI active
The system is unable to respond to the entered command while the
printer is in communication with the host interface processor.
Action 1. Terminate connection with HIP. (Refer to the HIP chapter in
your DocuPrint 96/DocuPrint 96MX LPS Operator Guide .)
2. Reenter the desired command.
OS1215 Input stopped after orderly shutdown
A software failure has caused a system rollover. Data being input has
stopped processing while the system attempts to reestablish the
correct state at the time of failure in an effort to recover all data.
Action Follow directions appearing at the system controller display to initiate
automatic job recovery and abort the analysis dump. (Refer to the
offline chapter in your DocuPrint 96/DocuPrint 96MX LPS Operator
Guide .)
OS1225 Automatic recovery initiated
Automatic job recovery has been initiated at the system controller
display after a system rollover due to software failure.
Action Follow directions appearing at the system controller display to
complete the recovery process.
OS1230 Separate not permitted with destination configuration
This is a response to SEPARATE ON or SEPARATE OFF when a
two-tray stacker is not present.
Action None.
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE