Xerox DocuPrint 96 Message Manual page 208

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-130
OS9989 Unable to acquire memory for device drivers:
Memory problems are sufficiently severe that there is not enough
memory to load hardware peripheral handler(s).
Action 1. Reboot the system by pressing the Boot button, then entering
B.
2. If the message reappears, contact your systems specialist or
Xerox Service Support Center.
OS9990 Fatal disk error reading device drivers:
A fatal system disk error occurred when executive attempted to load
the indicated hardware peripheral handlers.
Action Reboot the system by pressing the Boot button, then entering B.
If the message reappears, contact your systems specialist or Xerox
Service Support Center.
OS9991 Invalid or destroyed task images:
Indicated driver files required for operation of the system appear to
have been destroyed on the system disk.
Action 1. Reboot the system by pressing the Boot button, then entering
B.
2. If the message reappears, resysgen if authorized to do so (refer
to your DocuPrint 96/DocuPrint 96MX LPS System Generation
Guide ),
or
Contact your systems specialist or Xerox Service Support
Center.
OS9992 Driver task files not found:
This message is displayed at system boot time. This usually
indicates that a system generation was performed with a
configuration which does not match the current configuration.
Action Resysgen with the proper configuration, if authorized to do so, (refer
to your DocuPrint 96/DocuPrint 96MX LPS System Generation
Guide ),
or
Contact your systems specialist.
OS9993 Memory too degraded to load device drivers.
There is not enough memory to load the system device drivers.
Action Contact your systems specialist or Xerox Customer Service.
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE