Xerox DocuPrint 96 Message Manual page 122

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-44
OS1982 FCG exiting. Invalid profile encountered.
(4050/4090/4650 only) The system cannot accept the parameters or
values you have entered. The cause may be incorrect syntax, too
many characters, etc. This message is followed by message OS1976
PROFILE NOT LOADED.
Action 1. Verify that your values and/or syntax are correct and retry the
command.
2. If the message reappears, contact your supervisor or systems
specialist.
OS1983 FCG exiting. Failure to connect to the iot.
(4050/4090/4650 only) The FCG utility is unable to communicate with
the printer. There may be a print job or another system task being
processed.
Action 1. Retry the FCG command.
2. If the message reappears, look for other system or printer
messages to explain the condition.
3. If still unable to run FCG, contact your supervisor or systems
specialist.
OS1984 FCG exiting. Data value is out of range.
(4050/4090/4650 only) FCG has checked to see that all the data
values specified in your command are within allowable ranges before
updating the printer's non-volatile memory (NVM). Some values you
specified are out of range.
Action None.
Note: The percentage of wire left on the spool parameter must be
between 0 and 100 percent. A value greater than 100, for example,
would be out of range.
OS1990 Pre-format form - using system default paper size
The header of the specified form file lacks the proper edge mark
information which is needed by the system to determine paper size.
The system default paper size is used for the job.
Action None.
OS1991 No test patterns form available for specified source size
No test pattern form file is available for the paper size requested.
Action Select a different paper size and retry the command.
or
Abort the operation.
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE