Xerox DocuPrint 96 Message Manual page 197

XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE
OS8555 Drive xxx not useable: wrong disk ID.
The indicated disk drive cannot be used because it was moved from
another system and was not formatted for this one.
Action Reformat the disk. (Refer to your DocuPrint 96/DocuPrint 96MX LPS
System Generation Guide .)
OS8560 Drive xxx not useable: should be drive yyy.
The Indicated system disk drive was formatted as drive yyy, then
moved to xxx position. The system disk cannot be used in the new
position until reformatted.
Action Reformat the disk. (Refer to your DocuPrint 96/DocuPrint 96MX LPS
System Generation Guide .)
OS8600 Unsuccessful completion of send data directive.
Displayed after RESET of the job in progress has been confirmed
following a system disk error. (This message is followed by message
OS1000 READY FOR COMMANDS hh:mm:ss.)
Action None.
OS8650 Input has recovered to next job in queue.
During automatic job recovery following a system rollover, the input
task has attempted twice to recover data on the same page, and
once to recover the next report. Since this job apparently cannot be
printed, input moves to next job.
Action 1. Print the next job.
2. Submit an abort analysis dump (produced by system during
recovery process) to your systems specialist or Xerox
Customer Support.
OS8651 Output has recovered to next job in queue.
During automatic job recovery following a system rollover, the output
task has attempted twice to recover data on the same page, and
once to recover the next report. Since this job apparently cannot be
printed, output moves to the next job.
Action 1. Print the next job.
2. Submit the abort analysis dump (produced by system during
Recovery process) to your systems specialist or Xerox
Customer Service.
OS8700 Incorrect version of accounting file.
The accounting file is corrupt or outdated.
Action Contact your systems specialist or Xerox Customer Service for
assistance in obtaining correct software for the accounting file.
OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-119