Xerox DocuPrint 96 Message Manual page 134

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-56
OS2296 Log printing not allowed until system status='Idle
The system must be offline and not printing to process a log print
request.
Action Complete or abort any current jobs, enter the OFFLINE command
and then resubmit the log print request.
OS2310 Bin x not ready
For a system with one or two output tray(s), the selected output tray
is not ready to begin processing print jobs.
This message may be displayed after you have entered 'CONTINUE
O'. This message is followed by OS2000 ENTER 'CONTINUE O' TO
RESUME PRINTING, if printing is ready to begin.
Action None.
OS2320 Bin 2 not ready
The selected output tray must be ready in order for print quality
adjustment to start. If not, this message is displayed after you have
entered the CONTINUE O command. This message is followed by
OS2000 ENTER 'CONTINUE O' TO RESUME PRINTING.
Action None
OS2341 Printing can be resumed using standard page recovery, %n%+
or the entire finishing set can be reprinted, %n%+ Enter: "P" for
standard page recovery %n%+ "S" to reprint the entire set %n.
A jam has occurred during a report with SRECOVERY=ASK in effect.
Action Select the desired recovery option.
OS2342 Reprinting of the entire finishing set required %n%+. Discard
incomplete set from the finisher.
Segment recovery is in effect. Follow clearance instructions, then
press CONTINUE.
Action None.
OS2350 STiming value ignored. Use FCG to set device parameters.
An STIMING command has been detected in the datastream. This
command is ignored because the printer relies on the operator using
FCG to specify finishing-device timing parameters. This message is
informational only.
Action None.
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE