Xerox DocuPrint 96 Message Manual page 121

XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE
OS1979 NVM address . . .
(4050/4090/4650) This message either lists a series of four wire
management or seven third party device parameters for you to enter
or simply gives the current values.
n8 :% wire remaining on spool:
Action 1. Enter the requested wire management parameter values as
appropriate or contact your supervisor or systems specialist.
N
n9 : Stitcher disable
N10 : %low wire
Message threshold: n
or
n1 :Feature control: n
n2 :Skip pitch set: n
n3 :Delay sheet exit: n
n3 :Delay sheet exit: n
n4 :Sheet exit pulse: n
n5 :Delay end of set: n
n6 :End of set pulse: n
n7 :Delay all output:
2. Enter the requested finishing device parameter values as
appropriate.
Notes for device parameter values:
•
n1 :FEATURE CONTROL is 0.
•
n2 :SKIP PITCH SET is always 1.
•
For n3 through n 7 each value is doubled by the system.
(For example, if DELAY SHEET EXIT is equal to 50
milliseconds, you should specify a value of 25.)
•
n represents a value which corresponds to non-volatile memory
(NVM) locations in the system.
OS1980 Performing print quality adjustment.
This message informs you that print quality adjustment has started.
Action None.
OS1981 Print quality adjustment has been completed.
This message informs you that print quality adjustment has
completed successfully.
Action None.
OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-43