Xerox DocuPrint 96 Message Manual page 141

XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE
OS2683 Change housing for color printing or
This message is displayed when a problem occurs with the current
color housing. It is followed by these messages: OS2673 ENTER
THE SUB INK COMMAND OR ABORT THE PRINT JOB and
OS2000 ENTER 'CONTINUE O' TO RESUME PRINTING.
Action None.
OS2690 Ensure proper stock is loaded and output tray is empty
In response to a PQA command, this message reminds you to make
sure of the following:
•
The stock you want to use for the print quality adjustment
(PQA) is loaded in the paper tray
•
The target PQA output tray is empty.
Action None.
OS2691 Ensure proper stock is loaded for Print Job
This message appears after print quality adjustment is completed
when STOP was specified in the PQA command, or if you have
pressed the Stop button or entered PQA CANCEL.
Action Make sure the job stock is loaded.
Note: Be aware that if you enter the PQA CANCEL command, the
housing on which PQA was being performed will not be ready.
OS2692 Empty output tray
For a two output tray system, the selected output tray must be empty
in order for print quality adjustment to start. This message appears
after print quality adjustment is completed when STOP was specified
in the PQA command.
Action None.
OS2700 Key-in lost. Reenter.
The system was unable to process the command when entered
because another ongoing process temporarily conflicted with it.
Action Wait a few seconds and reenter desired command.
OS2705 Recovery in progress... keyin not allowed.
Recovery is currently in progress. The attempted operation was
ignored.
Action Wait for recovery to complete, following any additional instructions.
OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-63