Xerox DocuPrint 96 Message Manual page 50

IFU (INTERPRESS FONT UTILITY) MESSAGES
5-12
IF2250 Medium must be tape or cartridge.
Magnetic tape or cartridge are the only media possible for the ADD
command (some commands do not accept floppy disks).
Action Reenter the command specifying either magnetic tape or cartridge.
IF2304 Font profile name is required in ADD command
The ADD command must contain the desired font profile name.
Action Reenter the ADD command, to include the applicable font profile
name.
IF2306 Font profile x cannot be opened
The requested font profile cannot be opened.
Action 1. Verify that the font profile exists on the system and that it is not
corrupted.
2. Reenter the ADD command.
IF2318 Nonnumeric resolution parameter
The resolution of the font must appear numerically as 300 or 600 (spi)
in the IPFONTS or DCFONTS statement of the font profile.
Action 1. Correct the IPFONTS or DCFONTS statement using "300" or
"600" as the resolution parameter in the font profile.
2. Reenter the ADD command.
IF2324 Pt size x and orient y were not requested; skipping ADD
The expected point size and orientation have not been requested,
and the ADD command will not be processed.
Action None.
IF2330 Character x not found
The character shown in the message cannot be found within the FIS
font master.
Action 1. Verify that the character requested within the font profile is the
desired character.
2. Reenter the ADD command.
3. If the message reappears, contact your systems specialist or
Xerox Customer Support.
IF2332 Composite request (character x) requires RIP
The composite character requested in the font profile requires RIP
(raster image processor), which is not on your system.
Action None.
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE