Psc (Printer Subsystem Controller Command) Messages - Xerox DocuPrint 96 Message Manual

XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE
10.
controller command) messages
The PSC command enables the selectable download of a printer
controller and RIP software. (Refer to your DocuPrint 96/
DocuPrint 96MX LPS Operations Reference chapter on managing
LPS resources for additional information on the PSC command.)
PS1060 Initializing printer.
The printer is being processed and set at its starting values.
Action None
PS1061 Initializing CSI.
The printer controller software (CSI board) is being downloaded.
Action None.
PS1063 Downloading SCSI Firmware version xxxx.
The firmware is being downloaded from the system disk to the SCSI
controller.
Action None
PS1190 Invalid syntax.
The PSC command line contains incorrect syntax.
Action Reenter the command line using correct syntax. (Refer to your
DocuPrint 96/DocuPrint 96MX LPS Operations Reference chapter
on managing LPS resources for additional information.)
PS8888 PSC cannot complete due to an unrecoverable error.
A serious problem prevents PSC from completing the requested
download.
Action Contact your systems specialist or Xerox Customer Service.
PS9000 Printer failure. Enter 'PROBLEM'.
A printer failure has occurred.
Action Enter the PROBLEM command and respond to the messages
appearing on the keyboard display as appropriate.
10PSC (printer subsystem
10-1