Xerox DocuPrint 96 Message Manual page 143

XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE
OS2720 Invalid control key. Retry
The system cannot respond at this time to the function key that was
pressed due to a conflicting process or condition of the printer.
Action Wait until the process has completed and press the key again.
or
Press a different function key.
OS2725 Invalid drive unit specified.
The specified command refers to an invalid disk drive unit.
Action Check and retry command.
OS2726 Invalid tape device specified.
You have named a tape device that is not available on your system.
Action Verify the tape device number and retry the command.
OS2730 Requested task not found in system. Check and retry.
A command was requested that the system cannot perform, or a task
name was keyed in incorrectly.
Action 1. Verify the task name and enter it correctly.
2. If the message reappears, the task is not available on your
system.
OS2732 Command not allowed until printer is cycled down.
You have entered a command that cannot be processed until the
printer is inactive (cycled down).
Action Wait until the printer cycles down and then retry the command.
OS2733 Command not allowed while IOT is in service mode.
The command you have entered cannot be processed while the
printer is being serviced.
Action None.
OS2734 Command not allowed while in lockout mode.
You have entered a command that cannot be processed because the
system is in a lockout diagnostic mode.
Action None.
OS2737 Command not supported in this configuration.
The attempted command is not valid with this configuration.
Action Check and retry.
OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-65