Xerox DocuPrint 96 Message Manual page 200

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-122
OS8980 Unable to initiate input task.
The requested input task cannot be found or read from disk.
Action 1. Enter the RESET command.
2. Restart the job.
3. If the message reappears, reboot the system by pressing the
Boot button and entering B.
4. Restart the job.
5. If the problem continues, resysgen, if authorized to do so (refer
to your DocuPrint 96/DocuPrint 96MX LPS System Generation
Guide ),
or
Contact your systems specialist.
OS8985 Unable to initiate HIP task.
The HIP task cannot be started.
Action 1. Wait until the system is idle, then retry.
2. If problem persists, reload system software.
OS8989 Unable to initiate output task.
The system is unable to begin the indicated procedure, due to a fatal
software error. (This message usually appears in conjunction with
another message explaining the nature of the error condition.)
Action 1. Check the display for other relevant messages and follow
instructions given for it/them in this guide.
2. If the problem continues, contact your systems specialist or
Xerox Customer Service.
OS8990 Unable to initiate output task.
The requested output task cannot be found or read from disk.
Action 1. Enter the RESET command.
2. Restart the job.
3. If the message reappears, reboot the system by pressing the
Boot button and entering B.
4. Restart the job.
5. If the problem continues, resysgen if authorized to do so (refer
to your DocuPrint 96/DocuPrint 96MX LPS System Generation
Guide ),
or
Contact your systems specialist.
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE