Xerox DocuPrint 96 Message Manual page 131

XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE
OS2260 Paper in selected tray too large. Change if desired.
The paper length guide in the selected tray is set for paper of a larger
size than that set at mini-sysgen. Printing stops. (This message is
followed by message OS2000.)
The printer control console displays:
OUTPUT STOPPED. SEE MESSAGE AT CRT.
Action Enter CONTINUE O command, press the Continue button, or press
the <CON> key to resume printing. All subsequent paper size
mismatches are then ignored for the rest of the job.
or
1. Adjust the length guide and load paper of correct size. (Refer to
the chapter on feeder trays in your DocuPrint 96/
DocuPrint 96MX LPS Operator Guide. )
2. Enter the CONTINUE O command, press the Continue button,
or press the <CON> key to resume printing.
or
3. Enter the ABORT O command to cancel the job.
4. Perform mini-sysgen, if authorized to do so, to change default
paper size. (Refer to DocuPrint 96/DocuPrint 96MX LPS
System Generation Guide .)
5. Restart the job.
OS2261 Paper in selected tray too small. Change paper.
The paper length guide in the selected tray is set for paper of a
smaller size than that specified at mini-sysgen. Printing stops.
(Message is followed by message OS2000.)
The printer control console displays:
OUTPUT STOPPED. SEE MESSAGE AT CRT.
Action Adjust the length guide and load paper of correct size. (Refer to the
chapter on feeder trays in your DocuPrint 96/DocuPrint 96MX LPS
Operator Guide .)
1. Enter the CONTINUE O command, press the Continue button,
or press the <CON> key to resume printing.
or
2. Enter the ABORT O command to cancel the job.
3. Perform mini-sysgen to reset paper size. (Refer to the chapter
on feeder trays in your DocuPrint 96/DocuPrint 96MX LPS
Operator Guide .)
4. Restart the job.
OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-53