Xerox DocuPrint 96 Message Manual page 308

DOCUPRINT 96/DOCUPRINT 96MX LPS ADDITIONAL MESSAGES
15-38
FCG Exiting: Invalid Profile—Output or input not specified
The profile requires OUT135 prior to parameter 1 to determine if
these values are to be used for an output profile. if OUT135 has not
been included in the specified profile, the following message is
displayed:
Action None.
FCG Exiting: Invalid profile—too many parameters.
You have exceeded the acceptable number of parameters allowed in
the profile.
Action None.
FCG Exiting: Invalid profile—not enough parameters.
You have specified too few parameters in the profile.
Action None.
FCG Exiting: PVNUM.SYS not present on system
Necessary information for the FCG SHOW command is not in the
system.
Action None.
FCG Exiting: Profile for %0 successfully loaded
The profile you have requested has been found and its parameters
have been loaded.
Action None.
FCG Starting: Version: %0
You have entered a correct profile label. The appropriate version
number is also displayed.
Action None.
File cannot be accessed . . . .
The file is too large for the PC Editor to process.
Action If the file is an ESS file, use EDI in the message window.
File could not be emptied or deleted. Ensure that the filename is
valid.
An incorrect file name may have been entered, or the file name does
not exist.
Action 1. Check the file listing of the window you are working in for the
correct file name.
2. If the problem persists, contact your systems specialist.
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE