Xerox DocuPrint 96 Message Manual page 98

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-20
OS1262 Sysgen paper size out of range
If a paper size statement is not included in the JDL, the system will
use the values specified at SYSGEN. This message indicates that
the SYSGEN value is not supported by the IOT.
Action Perform a MINI SYSGEN and correct the default paper size.
OS1263 Form paper size out of range: xxxxxx.xxx
Paper size for form specified in the JSL is not supported by the IOT.
Action Contact your systems specialist.
OS1264 Barcode sequence mismatch
The IOT detected a sequence number other than the one expected.
Action Check the job, correct the reason for the mismatch and rerun.
OS1265 Printer status request already in progress
A previous request for printer status is still being processed.
Action None.
OS1266 A Barcode was specified, none found
The IOT did not detect a barcode where one was expected.
Action Check Read Head alignment, bar code programming or continue job
in BAR OFF mode.
OS1267 ESS didn't confirm duplex hint
A sheet abort request was sent to the ESS from the IOT because the
ESS did not confirm a hint for the second side of a sheet already
committed to the paper path.
Action None.
OS1268 Bar Align: sheet delivered. Seq1 = nn, Seq2 = nn
Sheets with sequence numbers have been read and delivered with
the printer operating in the bar align mode. Seq1 - front side, Seq2 -
back side.
Action None.
OS1269 Bar Align: sheet delivered
Sheets were delivered but no sequence numbers were read with the
printer operating in the bar align mode.
Action None.
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE