Xerox DocuPrint 96 Message Manual page 125

XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE
OS2007 Empty sample output tray
The sample tray contains more than 100 sheets. It must be emptied
for printing to resume.
The printer control console displays:
EMPTY SAMPLE TRAY
Action Remove output from the sample tray.
OS2008 CAUTION: paper size in selected tray has changed.
The paper size in a tray in the currently selected cluster has been
changed.
Action 1. Verify the change.
2. Change the paper, if desired.
3. Enter the CONTINUE O command or press the <CON> to
resume printing. (Refer to the chapter on feeder trays in your
DocuPrint 96/DocuPrint 96MX LPS Operator Guide .)
OS2009 Both trays are full
The SELECT AUTO command was entered. After the first
destination output tray was filled, the system was unable to switch
output to the other tray because it was also full. Printing stops.
Action 1. Unload both output trays. (Refer to the chapter on output trays
in your DocuPrint 96/DocuPrint 96MX LPS Operator Guide .)
2. Press the <CON> key or the Continue button, or enter the
CONTINUE command to resume printing.
OS2010 Mount input tape; 'CONTINUE I' when ready
The START command was entered offline. (Magnetic tape may
already have been mounted.)
Action 1. Load the magnetic tape reel for the job to be printed if you have
not already done so. (Refer to the offline chapter in your
DocuPrint 96/DocuPrint 96MX LPS Operator Guide .)
2. Enter the CONTINUE I command to start inputting data from
tape.
OS2020 Mount next volume 'CONTINUE I' when ready
A multivolume job is being processed. The system has encountered
the End of Volume magnetic tape label.
Action 1. Load the magnetic tape reel containing the next volume of the
report. (Refer to the offline chapter in your DocuPrint 96/
DocuPrint 96MX LPS Operator Guide .)
2. Enter the CONTINUE I command to resume input.
OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-47