Xerox DocuPrint 96 Message Manual page 136

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-58
OS2512 Color housing: not present
This message is displayed if a color housing is not installed in the
printer before the printer doors are closed.
Action None.
OS2513 Color housing is needed for this report
The printer requires a primary color which is not currently loaded.
Action Change the color housing to the one specified in the message.
OS2515 Black housing: not ready.
The black housing is not ready for any print jobs. Print quality
adjustment must be performed. This message is followed by these
messages: OS2681 PRINT QUALITY ADJUSTMENT IS REQUIRED
and OS2674 ENTER THE PQA COMMAND.
Action Enter the PQA command.
OS2552 Dry ink waste container not present
There is no dry ink waste container in place in the printer.
Action Install a dry ink waste container and begin printing your job.
OS2553 Replace developer waste container
The developer waste container is either full or missing.
Action Install a developer waste container if authorized to do so, or contact
your supervisor.
OS2556 Out of fuser lubricant. Add two tubes of fuser lubricant.
There is no fuser lubricant remaining in the system.
Action Add two tubes of fuser lubricant if authorized to do so, or contact your
supervisor.
OS2560 Please clean the tape drive before next tape mount.
Clean the magnetic tape drive before mounting the next tape drive.
(Refer to the maintenance chapter in your DocuPrint 96/
DocuPrint 96MX LPS Operator Guide .)
Action None.
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE