Dsr (Disk Save And Restore Command) Messages - Xerox DocuPrint 96 Message Manual

XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE
2.
These messages may appear during the process of saving all disk
files on tape or restoring all files to system disk from tape. (Refer to
your DocuPrint 96/DocuPrint 96MX LPS Operations Reference
chapter on managing LPS resources for additional information.)
DS1010 Save process complete
DS1020 DSR is saving disk drive 0.
DS1030 DSR is saving disk drive 1.
DS1040 DSR is saving disk drive 2.
DS1050 DSR is saving disk drive 3.
The DSR command was entered. The system has completed
backing-up system disk data on tape.
Action None.
DS2010 Mount and ready DSR tape
The DSR command was entered when no save tape had been
mounted.
Action Mount the save tape.
DS2020 Mount and ready DSR volume nnnn
The DSR process requires more than one save tape. The system has
encountered the EOV label.
Action Mount the indicated tape volume.
DS3010 Invalid parameter...DSR aborted
An incorrect density parameter was entered with the DSR command.
The DSR task has terminated.
Action Reenter the command as DSR or DSR 6250. No other parameters
are accepted.
DS3020 DSR Version 2.0 unable to run on this configuration
DSR version 2.0 is incompatible with the current printer
configuration.
Action None.
2DSR (disk save and restore
command) messages
2-1