Measuring Bioimpedance; Performing A Measurement (With Wifi Direct Connection To The Measuring Mat); Performing A Measurement; Mat) - Seca mVSA 535 Instructions For Use Manual

5.4 Measuring bioimpedance

Performing a measurement (with
WiFi direct connection to the
measuring mat)
➔
Performing a measurement (with WiFi direct connection to the measuring

mat)

➔
Performing a measurement (without WiFi direct connection to the
measuring mat)
➔
Connecting the measuring mat
➔
Canceling a measurement procedure
WARNING!
Hazard to patient, malfunction, damage to device
► Set up the device so that it cannot fall on patients.
► Route the cables and tubes of the measurement accessory so that
the patient cannot become entangled or be strangled.
► The device has no alarm function. Never leave the patient unob-
served during a measurement.
► Always connect only one individual patient to the device for each
measurement procedure.
Observe the points below in order to obtain meaningful and comparable
bio-impedance measurements:
• Amount of time patient should lie before each measurement:
Approx. 10 minutes
• If possible, arrange follow-up measurements at the same time of day
If a direct WiFi connection between the monitor and the measuring mat is
active, the measuring mat and the monitor communicate continuously. As a
result, some operating steps can be performed on both the monitor and the
measuring mat.
NOTE
If you are unsure whether the WiFi direct connection between the
monitor and the mat is active, contact your administrator.
1. Switch on the system ➔
2. Prepare the seca patient file ➔
The seca patient file is transmitted to the measuring mat.
3. Press the bia tab.
4. Wait until the position buttons on the monitor are active.
Switching the system on/off.
Preparing a seca patient
English
file.
Operation • 47