5.3 Updating the measuring mat software
148 •
seca mVSA 535
/
seca mBCA 525
NOTE
The software package for the monitor also contains data for the
measuring mat. If this data is more current than the software on the
measuring mat, the corresponding message will appear on screen.
Then proceed as described in the section entitled ➔
measuring mat
software.
In the following cases, it may be necessary to update the software of the
measuring mat:
• Monitor software has been updated (
)
seca mBCA 525
➔
Updating the monitor software
• System has had a measuring mat added (
➔
Retrofitting the measuring mat (seca mVSA 535 only)
• Measuring mat has been replaced with a new one (
)
seca mBCA 525
If the measuring mat software is out of date, the corresponding message will
appear on the monitor. In this case, proceed as outlined below:
1. Press the System tab.
2. Press the Measuring mat button.
3. Press the software update measuring mat button.
4. Follow the on-screen instructions.
5. Press the start software update button.
The software update will be installed.
Updating the
,
seca mVSA 535
)
seca mVSA 535
seca mVSA 535
,