Ground Control ® 3.0 Landing Gear; System Information; Operation; Prior To Operation - Lippert Components Ground Control 2.0 Master Owner's Manual

System Information

The Ground Control® 3.0 Landing Gear operate independently on uneven terrain. The landing gear feature
minimal wiring and each will have an in-line fused link to allow the landing gear to amp out when coming
into contact with the ground. The mini breakers on each landing gear also work as amp limiters. When an
out-of-sync landing gear is fully retracted, the breaker will trip and allow the other landing gear to fully
retract to again synchronize both landing gear. The landing gear system is for 5th wheel applications only.

Operation

Never attempt to operate the system without the footpad properly installed. Electric landing gear is
designed for vertical operation. Excessive side loads may cause damage to the landing gear. The bolt-on pull
pin MUST be inserted fully through both sides of the tube prior to use. Do not use landing gear to service the
trailer or change tires. Retract landing gear completely prior to moving the trailer.

Prior to Operation

The landing gear system should only be operated under the following conditions:
1. The trailer is parked on a reasonably level surface and the tires are chocked.
2.
Be sure all persons, pets and property are clear of the trailer while the landing gear system is in
operation.
3.
Make sure battery is fully charged.
Rev: 11.08.19
GROUND CONTROL
LEVELING AND STABILIZATION
3.0 LANDING GEAR
®
Page 134
CCD-0001573-08