Basic Jack Operation; Dropping Off Unit - Lippert Components Ground Control 2.0 Master Owner's Manual

Basic Jack Operation

1.
Front Landing gear jacks.
2. Rear leveling jacks.
Landing Gear jacks can be operated any time the system is "ON" but NOT in the "AUTO MODE." By pushing
the "FRONT" button, both front or landing gear jacks can be extended. By pushing either the "LEFT" or
"RIGHT" button, the individual front jacks can be extended. If the touch panel is put in the "RETRACT" mode,
indicated by the orange illuminated LED next to the "RETRACT" button, the front jacks can be retracted
together by pushing the "FRONT" button or individually by pressing either the "LEFT" or "RIGHT" button.
The rear jacks can only be operated when the touch panel is in the "MANUAL MODE." Once system is in
"MANUAL MODE," pressing the "REAR" button will extend both rear jacks at the same time. To operate
individual rear jacks, press the "LEFT" or "RIGHT" button first, depending on what is needed at the time, then
press the "REAR" button and hold both at the same time.

Dropping Off Unit

1.
Park coach on level ground.
2.
Chock all tires.
3.
Make sure battery power is on.
4.
Release front jack legs to within 4-5 inches from the ground by pulling out the quick release pin (Fig. 1A).
5.
Release inner legs on rear leveling jacks — 2 (4-point) or 4 (6-point) — by pulling the quick release pins.
6.
At this point, you may use automatic controls on your Linc™ remote if supplied. If no Linc remote is supplied,
continue to step 7. IMPORTANT: For Linc™ automatic leveling and retraction instructions, refer to your owner's
packet.
7.
Press "ON/OFF" button to turn panel on (Fig. 2E).
8.
Push "UP ARROW" button (Fig. 2A) and scroll to "DROP FRONT JACKS" option on LCD screen.
9.
Push "ENTER" button (Fig. 2B). Front legs will lower to ground and stop.
10.
Disconnect 5th wheel latch.
11.
Push "FRONT" button (Fig. 2D) to extend front landing gear jacks manually and lift front of vehicle to clear 5th
wheel plate.
12.
Pull tow vehicle away and park at a safe distance.
13.
Push "AUTO LEVEL" button (Fig. 2C). The unit will commence auto-level feature by setting front landing
gear jacks to level, then dropping rear jacks followed by a leveling sequence check. On the 6 point
system, the middle jacks will now lower to the ground to stabilize the unit. When auto-level sequence
is complete, LCD screen will indicate, "AUTO LEVEL SUCCESS." "Level Jacks: Down" will then appear,
along with a green light in the middle of the jack buttons.
14.
Press the "ON/OFF" button (Fig. 2E) to turn system off.
A
Rev:11.08.19
Fig. 1
A
B
Page 12
Fig. 2
D
C
E
CCD-0001573-08