Operation - Linc Remote; Configuring The Linc Remote - Lippert Components Ground Control 2.0 Master Owner's Manual

Operation - Linc Remote

Configuring the Linc Remote

NOTE: If the trailer does not have a LCI Multifunction wireless system installed, each of the listed functions
(Fig. 22) steps 1-7 will read as "NONE."
1.
Turn the Linc Remote "On" by pressing and releasing the large silver button at the bottom of the
remote (Fig. 17A).
A. If the remote has never been configured, it will display the "Config" button (Fig. 17B) immediately
after it is turned on.
B. To reconfigure the remote after the initial programming, push the silver button five times
(Fig. 17A).
2. Press the "Config" button (Fig. 17B) on the touch screen to begin configuring the remote.
3.
Using the arrow buttons (Fig. 18A) at the bottom of the screen, navigate to the specific items the
remote will control.
4. When the name of the item appears in the middle of the screen (Fig. 18B), press the large "SELECT"
button (Fig. 18C).
5.
Assign an item or "None" to each of the function spaces available.
6.
Press the SELECT button at each screen.
NOTE: Without a LCI Multifunction Wireless system installed on the trailer, no other functions will be able
to be programmed on the remote.
Fig. 17
B
A
7.
If remote was purchased before July 2013, refer to Step A, if purchased after July 2013, refer to Step B.
C. After all the functions have been assigned a "title," the next screen will ask: "Configure Leveler?"
(Fig. 19). If trailer is so equipped, and you want to have leveling available on your transmitter,
select "YES." If not, select "NO" (Fig. 19).
D. After all the functions have been assigned a "title," the next screen will ask: "Configure Leveler
Type 1?" (Fig. 20) and then "Configure Leveler Type 2?" (Fig. 21) will appear. If syncing the
transmitter to a LCI Level Up, Ground Control® or Motorized Dual Sensor system, select "YES" for
Type 1 and "NO" for Type 2. If you will not be syncing the transmitter to either of these leveling
systems select "NO" for both Type 1 and Type 2.
8.
A confirmation screen will appear showing all of the configured functions (Fig. 22). If the trailer
does not have a LCI Multifunction Wireless system installed, the screen will show "NONE" for the
listed functions, then "Leveler Type 1: Yes" and :Leveler Type 2: No." Press "OK" button to save the
configuration or the "Cancel" button to restart the process.
9.
Once a configuration is saved, a "Config Fuses?" screen (Fig. 23) will appear. Press "NO" button, since
any fuse configuring will need to be done by the manufacturer of the trailer.
Rev:11.08.19
Fig. 18
B
A
C
Fig. 19
Page 66
Fig. 20
Fig. 21
CCD-0001573-08