Unhitching From Tow Vehicle; Auto Level - Lippert Components Ground Control 2.0 Master Owner's Manual

Unhitching From Tow Vehicle

1.
Before unhitching the trailer, make sure trailer is parked on a level surface.
2. Make sure the ground surface under the Power Tongue Jack is firm and level.
3.
Make sure the footpad of the Power Tongue Jack is pinned securely in place with the clevis pin and
hairpin cotter pin.
4.
Chock all tires of the trailer.
5.
Disconnect any wires, chains, or sway controls that may be equipped between the tow vehicle and the
trailer.
6.
Unlatch the trailer coupler.
7.
Press and hold the "EXT" button (Fig. 7A) on the Power Tongue Jack or press the "Front" button (Fig.
4A) on the OneControl Touch Panel in standard mode to extend the Power Tongue Jack until the
footpad touches the ground and the coupler clears the hitch ball.
8.
Once the coupler is clear of the hitch ball, move the tow vehicle a safe distance away from the trailer.

Auto Level

NOTE: Once the automatic leveling cycle has been started, it is important that there is no movement in the
trailer until the leveling process is complete. Failure to remain still during the leveling cycle could
have an effect on the performance of the leveling system.
1. Follow steps 1-6 in "Unhitching From Tow Vehicle" section.
2.
Use Power Tongue Jack to lift coupler off of hitch ball.
3.
Move the tow vehicle a safe distance away from the trailer.
4. Press "AUTO LEVEL" button (Fig. 8A).
NOTE: Pressing any button on the touch panel will "ABORT" the auto leveling cycle during an Auto Level
sequence.
Rev:11.08.19
Fig. 7
A
Page 59
Fig. 8
A
CCD-0001573-08