Troubleshooting; Fuse; Clutch; Additional Information Sources - Lippert Components Ground Control 2.0 Master Owner's Manual

Troubleshooting

Fuse

1.
The power tongue jack has a motor, clutch and a 30A fuse. The 30 Amp fuse will be located in-line and
will need to be replaced with a 30A ATO-type fuse if it blows.
2. The battery must be fully charged prior to operating the power tongue jack. Low voltage from the
battery will cause the fuse to blow prematurely.
3.
The ON and OFF switch (Fig. 2) controls the power tongue jack's light only. If left on for an extended
period of time, the light will drain the trailer's battery.

Clutch

The clutch will slip under two conditions:
1. The power tongue jack has reached its extend or retract limit.
2.
The tongue weight of the trailer has exceeded the capacity limits of the power tongue jack.
A. Items stored in the trailer can vastly influence the weight distribution of the power tongue jack.
Reorganize stored items if the power tongue jack motor clutch continues to slip.
B. Release the switch immediately when the clutch noise occurs. The clutch is the overload
protection for the motor. The clutch should not slip during normal operation. This will cause
excessive wear on the clutch and the motor.

Additional Information Sources

Additional information about this product can be obtained from
the free myLCI app. The app is available on iTunes® for iPhone® and iPad® and also on Google Play™ for
Android™ users.
iTunes®, iPhone®, and iPad® are registered trademarks of Apple Inc.
Google Play™ and Android™ are trademarks of Google Inc.
Rev:11.08.19
lci1.com/support
Page 130
or by downloading
CCD-0001573-08