Operation; Unhitching From Tow Vehicle; Hitching To Tow Vehicle - Lippert Components Ground Control 2.0 Master Owner's Manual

Operation

NOTE: The ON and OFF light switch (Fig. 2) controls the power tongue jack's light only. If left on for an
extended period of time, the light will drain the trailer's battery.
NOTE: The power tongue jack is designed for vertical movement of the trailer only.

Unhitching From Tow Vehicle

1.
Chock the tires of the trailer.
2.
Make sure the footpad of the power tongue jack is pinned securely in place with the clevis pin and
hairpin cotter pin (Fig. 1A).
3. Make sure the ground surface under the power tongue jack is firm and level.
4.
Push EXT (Fig. 2B) to extend the power tongue jack until the footpad touches the ground and the
coupler clears the hitch ball.
5. Disconnect all electrical and mechanical connections between the trailer and tow vehicle.
6.
Move the tow vehicle away from the trailer.
7.
Push RET (Fig. 2A) as needed to return the front of the trailer to level.

Hitching to Tow Vehicle

1.
Chock the tires of the trailer.
2.
Press EXT (Fig. 2B) if needed to allow the coupler to clear the hitch ball.
3. Push RET (Fig. 2C) to retract the power tongue jack until the coupler properly mounts the hitch ball
and the leg of the power tongue jack is fully retracted.
NOTE: Make sure the leg of the power tongue jack (Fig. 1B) is fully retracted prior to moving the tow vehicle.
B
A
Rev:11.08.19
Fig. 1
Light
Switch
Page 128
Fig. 2
A
B
CCD-0001573-08