System Maintenance; Mechanical Maintenance; Troubleshooting - Lippert Components Ground Control 2.0 Master Owner's Manual

System Maintenance

Do not work on the stabilizer unless the battery is disconnected. Failure to act in accordance with the
following may result in death, serious personal injury or severe product or property damage.

Mechanical Maintenance

It is recommended that when operating in harsh environments, e.g. road salt or ice buildup, the moving
parts be kept clean. They can be washed with mild soap and water. The ACME screw is precoated with
grease. If the screw is cleaned, it may be necessary to add grease to the screw to ensure smooth stabilizer
operation.
Operating the stabilizer without grease on the screw could lead to product failure.
Electrical Maintenance
For optimum performance, the system requires full battery current and voltage. The battery must
be maintained at full capacity. Other than good battery maintenance, check the terminals and other
connections at the battery, the control switch and the electric motors for corrosion and loose or damaged
terminals. Check motor leads under the trailer chassis. Since these connections are subject to damage from
road debris, make sure they are in good condition.

Troubleshooting

What Is Happening?
System shuts off
Switch does not
activate system
Rev:11.08.19
Why?
Too much weight.
Low voltage.
Damaged or
disconnected wiring.
What Should Be Done?
Circuit protection will reset in 10 seconds.
Test battery voltage under load. Charge or replace.
Use Manual Override.
Check wiring. Repair or replace.
Use Manual Override.
Page 108
CCD-0001573-08