Auto Level Sequence; Hitch Recognition - Lippert Components Ground Control 2.0 Master Owner's Manual

Auto Level Sequence

NOTE: Sequence may vary slightly based on the height of the trailer coupler prior to leveling.
5.
When the Auto Level Sequence begins, it will make sure that the rear jacks are retracted first.
6.
The Power Tongue Jack will ground.
7.
Front jacks will lower close to level.
8. Rear jacks will deploy and ground.
9.
Trailer will level front-to-rear and then side-to-side.
10. The Auto Level Sequence will ground all leveling jacks to ensure all foot pads are on the ground, then
the display will show complete.
NOTE: Step 5 may repeat several times, if the controller deems necessary.
If the "AUTO LEVEL" sequence does not perform as intended, place the system in Manual Mode. Test that the
jacks operate correctly by pushing their corresponding buttons on the touch panel; e.g., "Front" button only
operates the front jacks.

Hitch Recognition

1.
Press the "On/Off" button (Fig. 9A) to turn the touch panel "On".
2.
Press "AUTO HITCH" (Fig. 9C) button to retract rear jacks.
NOTE: The rear leveling jacks will retract, followed by the tongue jack extending to the ground, then
followed by the front leveling jacks retracting. The tongue jack will then adjust the height of
the front of the trailer coupler to the point at which the "AUTO LEVEL" button (Fig. 9B) was most
recently pressed.
3.
Press the "On/Off" button (Fig. 9A) to turn the touch panel "Off".
4. Back the tow vehicle into position to align the tow vehicle's hitch with trailer's coupler.
5.
Press and hold "RET" button (Fig. 10A) on the tongue jack to retract the Power Tongue Jack until the
coupler sets into position on top of the tow vehicle hitch.
6. Latch the tow vehicle hitch and reconnect any wires, chains or sway control that may be equipped
between the tow vehicle and trailer.
7.
Press the "RET" button (Fig. 10A) twice, then press and hold the "RET" button for 3-5 seconds to engage
the tongue jack's Auto Retract feature.
NOTE: To utilize the Power Tongue Jack for the hitching process, see "Operation - Power Tongue Jack"
section.
Rev:11.08.19
Fig. 9
A B C
Page 60
Fig. 10
A
CCD-0001573-08