Unhitching Instructions; Auto Level Sequence; Hitch Recognition - Lippert Components Ground Control 2.0 Master Owner's Manual

2.
Level-Up Jacks
C. The Level-Up jacks operate when "AUTO MODE" is activated or the touchpad is in "MANUAL
MODE." Once the system is in "MANUAL MODE," press the REAR Button (Fig. 1J) to extend all Level-
UP jacks at the same time.
NOTE: Manual and Auto modes can be selected through the LCD menu by using the Up and Down Arrow
buttons (Figs. 1A and 1B), then press ENTER (Fig. 1C) to select the desired mode
D.
Press the LEFT or RIGHT buttons (Fig. 1H or 1I) to operate Level-Up jacks on the left (roadside) or
right (curbside) side of the 5th Wheel, respectively.

Unhitching Instructions

1. Press Power Button (Fig. 1K) (ON) to turn system on. LCD screen (Fig. 1E) lights up.
2.
LCD screen will read "NOT LEVEL Jacks: UP."
NOTE: Indicator (LED) lights (Fig. 1) may come on, indicating the current disposition of the 5th Wheel.
3.
Press FRONT Button (Fig. 1G) to extend landing gear jacks and lift front of 5th Wheel to take the weight
of the 5th Wheel off of the hitch.
4.
Uncouple the 5th Wheel connection from the tow vehicle.
5. Pull tow vehicle away and park it at a safe distance.

Auto Level Sequence

Prior to unhitching from the tow vehicle, make sure the 5th Wheel is parked on a level surface and the tires
are chocked.
1.
After unhitching from tow vehicle, press AUTO LEVEL (Fig. 1F).
NOTE: Pressing any button during an auto level sequence will abort the auto leveling cycle.
NOTE: In order for the hitch recognition feature to function, the auto level sequence MUST be started with
the front of the 5th Wheel above level.
2. Front landing gear will retract, lowering the front of the 5th Wheel below level, stopping, then lifting
the front end to level the 5th Wheel front-to-back.
3.
The left side leveling jack extends and raises the roadside of the 5th Wheel.
4.
The right side leveling jack extends and raises the curbside of the 5th Wheel, beginning side-to-side
leveling.
5.
The front landing gear extends to complete the leveling cycle.
6.
Additional left-to-right or front-to-back leveling may occur, if the controller deems it necessary.
NOTE: If the Auto Level sequence does not happen as stated above, check to ensure proper manual
function in all zones.

Hitch Recognition

1.
Turn on touchpad.
2. Press the LEFT and RIGHT buttons (Fig. 1H and 1I) simultaneously.
3.
The front of the 5th Wheel will raise to the height where the auto level sequence was started.
NOTE: If the auto level sequence was started with the front of the 5th Wheel in a below level condition, the
Hitch Recognition will not function and the LCD screen will read "Feature Disabled." For the hitch
recognition feature to function, the auto level sequence MUST be started with the front of the 5th
Wheel above level.
4.
Connect the tow vehicle to the 5th Wheel. Make sure hitch is connected and locked.
5.
Press Up Arrow button (Fig. 1A) until LCD screen reads "AUTO RETRACT."
6. Press ENTER button (Fig. 1C). System will immediately retract all jacks and landing gear.
Rev:11.08.19
Page 146
CCD-0001573-08